Damp Proofing Protection System Components which ensure effective jointing, continuity and protection

The following components are used within the Visqueen damp proofing protection systems to ensure effective jointing, continuity and protection. Separate datasheets relating to the damp proof membranes and courses are available.

components

  • Double Sided Jointing¬†Tape
  • VisqueenPro Single Sided Jointing Tape
  • Rigid Preformed Pipe Sleeve (Top Hat) Unit
  • Flexible Preformed Pipe Sleeve (Top Hat) Unit
  • Heavy Duty Protection Board
  • Zedex DPC Jointing Tape
  • Zedex DPC Fixing Strip
  • Zedex DPC Fixing Pins for Masonry
  • Zedex DPC Fizing Pins for Insulation
  • Visqueen Detailing Strip
  • Visqueen HP Tanking Primer

Installation of damp proofing protection components:

Ensure surfaces are smooth, clean and dry. Prime the substrate to which the strip is to be adhered with Visqueen Tanking Primer and allow drying. Do not apply primer to surface of membrane. Cut the strip to size ensuring overlap of minimum 150mm on to the membrane and the primed substrate. Progressively remove the release paper while pressing the strip firmly on to the surface. Work from the centre of the strip outwards to remove any trapped air.

When the weather is cold, store strip in a warm, dry place until required. Installation is not recommended below 5C.

The following items are available to view online or to download from www.visqueenbuilding.co.uk

  • Technical Datasheets
  • Typical installation
  • CAD details
  • Health and Safety data

Register online for access to NBS Clauses and for information about our CPD Seminars.

For advice on detailing or installation call Visqueen Building Products Technical Help Line 0845 302 4758.

For advice on detailing or installation call Visqueen Building Products Technical Help Line 0845 302 4758.

Follow us on:

 

Leave a Reply

Your email address will not be published. Required fields are marked *